Covering Northampton and the surrounding area Monday to Friday 9:00am - 5:00pm Get a quote

Vehicle Graphics in Wootton - Aftercare and Maintenance That Makes Them Last

Getting vehicle graphics fitted in Wootton is only half the story - how you look after them determines how long they perform and how sharp they keep looking.

5.0 from 9 Google reviews Est. 2020 Quoted in writing first Nothing printed until you sign off the proof Fitting arranged at your site

What We Fit and How

We apply vehicle graphics to cars, vans, lorries, trailers and fleet vehicles. The range covers cut vinyl lettering, digitally printed panels, partial wraps and full wraps. We design and print everything in-house, then come out to you in Wootton and fit at your premises - no need to take a working vehicle anywhere.

Once the job is done and the vehicle is back in use, what happens next is largely down to the owner. Good aftercare is not complicated, but it makes a real difference to how long the graphics perform and whether they still look professional a few years from now.

The First 48 to 72 Hours Matter

Freshly applied graphics need time for the adhesive to cure fully. In the first two to three days after fitting, avoid pressure washing, automated car washes with rollers or brushes, and prolonged exposure to heavy rain where possible. The edges of the film are the most vulnerable at this stage - the adhesive is still reaching its full bond strength, particularly in cold conditions.

During this initial period, keep the vehicle out of standing water where the wheels and lower panels are submerged. Driving normally is fine; it is prolonged soaking and mechanical pressure that can interfere with the cure.

Washing: What to Use and What to Avoid

Hand washing is the safest method for graphicked vehicles throughout their life. Use a mild, non-abrasive vehicle shampoo with a soft cloth or sponge. Work top-down, rinse thoroughly and dry with a clean chamois or microfibre cloth rather than leaving water to sit on the surface.

Automated roller washes are the biggest source of avoidable damage to vehicle graphics. The rotating brushes get under edges, particularly around door handles, mirrors and the bottom of panels, and cause lifting that would not otherwise happen. If the vehicle goes through a wash bay regularly, that is likely where edge lifting will start first.

Pressure washing is acceptable on a cured graphic but keep the nozzle at least 30 centimetres from the surface and angle it parallel to the edges of the film rather than directly at them. Never direct a pressure washer jet at the edge of a panel at close range - that is the fastest way to get the film to start peeling.

Fuel and Chemicals

Petrol, diesel and screen wash can damage printed graphics if they are allowed to sit on the surface. At the pump, wipe off any fuel splashes immediately with a damp cloth rather than leaving them. The same applies to bird droppings, tree sap and road salt. These are mildly acidic or abrasive and will degrade the surface of the film if left for extended periods. Wiping them off when you spot them takes thirty seconds and avoids a problem that builds over months.

Avoid using solvent-based cleaning products, petrol-based degreasers or strong traffic film remover directly on the graphic area. For stubborn grime on a graphicked panel, isopropyl alcohol on a soft cloth, used sparingly, is safer than a heavy chemical product.

Parking and Storage

Where a vehicle is parked regularly affects how the graphics age. Prolonged exposure to direct sun causes fading in printed graphics over time, particularly on south-facing panels. If you have the option to park under cover or in shade, particularly during long periods when the vehicle is not in use, that will slow fading noticeably.

Similarly, vehicles parked near industrial sites, agricultural areas or coastal locations pick up surface contaminants more quickly. Regular washing is more important in those environments than it would be for a vehicle kept in a clean yard.

Inspect the Edges Regularly

A simple visual check every few months catches problems before they become expensive. Run a finger along the edges of panels - around door handles, the bottom of side graphics, the rear doors and any edges that go around curves. If you feel an edge starting to lift, that is the time to get it looked at, not six months later when the lifted section has grown and allowed dirt and moisture underneath.

Small areas of lifting can often be re-adhered cleanly if caught early. Left for months, the film stretches and distorts and the section may need replacing rather than just re-sticking.

What to Do About Minor Damage

Scratches and scuffs from minor vehicle contact are part of working life for a tradesperson's van. A light surface scratch that has not broken through the film may be barely visible once the area is cleaned properly. A scratch that cuts through the print layer is a different matter - water can get into the break and cause lifting around it.

For cuts or abrasions that go through the film, the realistic options are a localised patch repair using matched material, or leaving it and monitoring whether it spreads. Attempting to seal it yourself with general-purpose adhesive or tape usually makes the problem worse by contaminating the surface for any future repair.

Fleet Vehicles: Building Maintenance Into Routine

For small business owners running more than one vehicle in and around Wootton, the most practical approach is to build a quick graphics check into whatever vehicle inspection routine you already have. If drivers do a weekly walkaround, add edge condition and surface damage to what they look for. Catching a lifting corner early is a ten-minute job. Letting it run until a large section needs re-doing is a half-day job and costs proportionally more.

Keep a note of when each vehicle was graphicked. Printed graphics on a well-maintained vehicle typically look good for several years - the exact lifespan depends on the material used, how the vehicle is washed and where it is kept, but regular care makes a significant difference to whether you are at the lower or upper end of that range.

Removal When the Time Comes

When a vehicle is due for a rebrand or is being sold, we remove existing graphics as part of our service. Removal is much cleaner on a graphic that has been well maintained than on one that has been left to degrade. Brittle, over-aged film tends to come off in small pieces and leaves more adhesive residue, which takes longer to clean back to bare paint. That is another practical reason why maintenance pays off over time.

To book a graphics fitting in Wootton or to ask about maintenance advice for an existing job, call us directly and we will talk through what you need.

Why use us in Wootton

  • Your design shown on your vehicle before printing.
  • Graphics designed and printed by us.
  • We fit at your premises in Wootton.
  • We are insured.

Vehicle Graphics in Wootton?

Phone us or fill in the form. A few details about the vehicles are enough for us to start on a written quote.

Call Quote